Get Started#

This guide is for the administrator. Do the tasks in the order below. Do them on the central Hermes host, unless the page says otherwise.

  1. System Requirements: Check the central host, the edge nodes, and the network.

  2. Install Hermes, Set the Persona, and Bring Up the WebUI: Install Hermes and a local model, apply the persona, and start the WebUI.

  3. Prepare the Edge Nodes: Create the deployment account on each node. Set a proxy if your network needs one.

  4. Configure the Inventory and Deploy: Edit the inventory, run the installer, and verify the MCP registration.

Note

Tasks 2 and 3 do not depend on each other. You can prepare the edge nodes while you set up the central host. Do both before task 4.

When deployment is complete, give access to the operators. See Use Hermes as an Operator.