# Get Started This guide is for the administrator. Do the tasks in the order below. Do them on the central Hermes host, unless the page says otherwise. 1. [System Requirements](./get-started/system-requirements.md): Check the central host, the edge nodes, and the network. 2. [Install Hermes, Set the Persona, and Bring Up the WebUI](./get-started/set-up-central-host.md): Install Hermes and a local model, apply the persona, and start the WebUI. 3. [Prepare the Edge Nodes](./get-started/prepare-edge-nodes.md): Create the deployment account on each node. Set a proxy if your network needs one. 4. [Configure the Inventory and Deploy](./get-started/deploy-the-fleet.md): Edit the inventory, run the installer, and verify the MCP registration. > [!NOTE] > Tasks 2 and 3 do not depend on each other. You can prepare the edge nodes while you set up > the central host. Do **both** before task 4. When deployment is complete, give access to the operators. See [Use Hermes as an Operator](./how-to-guides/use-hermes-as-operator.md). :::{toctree} :hidden: ./get-started/system-requirements Set Up the Central Host <./get-started/set-up-central-host> ./get-started/prepare-edge-nodes ./get-started/deploy-the-fleet :::